7 open source boards using the INA228
Real designs built with the INA228, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
AVR/ArduinoDiyBMS-CurrentShunt
stuartpittaway
90 × 72 mm45 parts2LCC-BY-NC-4.057
ESP32Dcpower
hnz1102
58 × 90 mm101 parts2LNo license1
ESP32Zone syntax test
gokcesena53
90 × 55 mm89 parts4LMIT0
STM32Inference servers
embeddedos-org
420 × 300 mm637 parts16LMIT8
STM32Rad tolerant electronics
233 × 220 mm547 parts16LMIT8
STM32Hardware security modules
300 × 200 mm510 parts16LMIT8
STM32Npu subsystems
120 × 90 mm460 parts14LMIT8
The INA228 in open source designs
The gallery holds 7 open source boards using the INA228 from 4 GitHub repositories; a typical one measures about 120 × 90 mm and carries around 460 components.
71% use four copper layers or more, and 71% carry an open source license.
The most starred is DiyBMS-CurrentShunt by stuartpittaway.
Microcontrollers on boards using the INA228
What boards using the INA228 are built for
INA228: common questions
Where can I find a INA228 reference design?
Each of the 7 boards on this page is a real design using the INA228. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the INA228 use?
Most are built on STM32 (4), ESP32 (2) and AVR/Arduino (1).
How big is a typical board using the INA228?
The median is 120 × 90 mm, and 29% are two-layer designs.
What is the most popular open source board using the INA228?
By GitHub stars, DiyBMS-CurrentShunt by stuartpittaway, with 57 stars.
Can I simulate one of these boards using the INA228 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.