8 open source boards using the 4077

Real designs built with the 4077, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

8 boardsClear filters|Most starred

How designs wire the 4077

Read from the KiCad layouts of 6 open source designs, one per repository: what each pin of the 4077 connects to, and the resistors, capacitors and other passives placed on it.

  • The VDD pin has a decoupling capacitor on 4 of 6 designs, most often 100 nF.
Pin 2Connected to: A connector 33%
  • Series resistor on 33% · 10 kΩ (1)
Pin 4Connected to: Signal 67% · not connected 33%
  • Series resistor on 33% · 270 Ω (1), 10 kΩ (1)
Pin 5Connected to: A connector 33% · not connected 17% · GND 17%
  • Series resistor on 33% · 10 kΩ (2)
VSSpin 7Connected to: GND 83% · a signal 17%
VDDpin 14Connected to: 5V 83% · a signal 17%
  • Decoupling capacitor on 67% · 100 nF (4)

9 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include MSX IDC Adapter by costarc, SPU2 by rraider, Automata Generator Standard by Sirawit7205 and Xnl by 0x007E.

The 4077 in open source designs

The gallery holds 8 open source boards using the 4077 from 6 GitHub repositories; a typical one measures about 100 × 73.7 mm and carries around 86 components.

88% are two-layer designs, the rest use four layers or more, and 50% carry an open source license.

The most starred is SPU2 by rraider.

Parts used alongside the 4077

Microcontrollers on boards using the 4077

4077: common questions

Where can I find a 4077 reference design?

Each of the 8 boards on this page is a real design using the 4077. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What decoupling capacitors do designs use on the 4077 VDD pin?

The VDD pin has a decoupling capacitor on 4 of 6 designs, most often 100 nF. Counted from the KiCad layouts of 6 open source designs using the 4077.

Which microcontrollers do boards using the 4077 use?

Most are built on AVR/Arduino (4).

How big is a typical board using the 4077?

The median is 100 × 73.7 mm, and 88% are two-layer designs.

What is the most popular open source board using the 4077?

By GitHub stars, SPU2 by rraider, with 7 stars.

Can I simulate one of these boards using the 4077 before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part