2 open source boards using the DIP-Switch
Real designs built with the DIP-Switch, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
Pd buck converter
bernardopezzo
215.3 × 30.1 mm20 parts2LNo license0Usb pd buck converter
bernardopezzo215.3 × 30.1 mm20 parts2LNo license0
The DIP-Switch in open source designs
The gallery holds 2 open source boards using the DIP-Switch from 2 GitHub repositories; a typical one measures about 215.3 × 30.1 mm and carries around 20 components.
100% are two-layer designs, the rest use four layers or more, and 0% carry an open source license.
The most starred is Usb pd buck converter by bernardopezzo.
Parts used alongside the DIP-Switch
What boards using the DIP-Switch are built for
DIP-Switch: common questions
Where can I find a DIP-Switch reference design?
Each of the 2 boards on this page is a real design using the DIP-Switch. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
How big is a typical board using the DIP-Switch?
The median is 215.3 × 30.1 mm, and 100% are two-layer designs.
What is the most popular open source board using the DIP-Switch?
By GitHub stars, Usb pd buck converter by bernardopezzo, with 0 stars.
Can I simulate one of these boards using the DIP-Switch before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.