7 open source boards using the SOT-23-5

Real designs built with the SOT-23-5, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

7 boardsClear filters|Most starred

How designs wire the SOT-23-5

Read from the KiCad layouts of 5 open source designs, one per repository: what each pin of the SOT-23-5 connects to, and the resistors, capacitors and other passives placed on it.

GNDpin 2Connected to: GND 80% · not connected 20%
NCpin 4Connected to: Not connected 80% · VBUS 20%
VOUTpin 5Connected to: 3.3V 80% · a signal 20%

2 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Ai hardware engineering team by ktanino10, Bongo pod by BeanieMen, Serene Mini by cshariq and Rev a by jackalkahwati.

The SOT-23-5 in open source designs

The gallery holds 7 open source boards using the SOT-23-5 from 7 GitHub repositories; a typical one measures about 117 × 72 mm and carries around 49 components.

57% use four copper layers or more, and 0% carry an open source license.

The most starred is Ai hardware engineering team by ktanino10.

Parts used alongside the SOT-23-5

Microcontrollers on boards using the SOT-23-5

What boards using the SOT-23-5 are built for

SOT-23-5: common questions

Where can I find a SOT-23-5 reference design?

Each of the 7 boards on this page is a real design using the SOT-23-5. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

Which microcontrollers do boards using the SOT-23-5 use?

Most are built on ESP32 (2), Raspberry Pi (2) and STM32 (1).

How big is a typical board using the SOT-23-5?

The median is 117 × 72 mm, and 43% are two-layer designs.

What is the most popular open source board using the SOT-23-5?

By GitHub stars, Ai hardware engineering team by ktanino10, with 1 stars.

Can I simulate one of these boards using the SOT-23-5 before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part