5 open source boards using the USBLC6-2SC6Y

Real designs built with the USBLC6-2SC6Y, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

5 boardsClear filters|Most starred

How designs wire the USBLC6-2SC6Y

Read from the KiCad layouts of 5 open source designs, one per repository: what each pin of the USBLC6-2SC6Y connects to, and the resistors, capacitors and other passives placed on it.

  • The VBUS pin has a decoupling capacitor on 3 of 5 designs, most often 1 µF (then 22 µF).
GNDpin 2Connected to: GND 100%
VBUSpin 5Connected to: 5V 80% · a signal 20%
  • Decoupling capacitor on 60% · 1 µF (2), 22 µF (1)

3 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Zs1100a by zscircuits, STM32F103 dev board by christophmeyer, Devboard by zPirroZ3007 and Farseer by jamesmarrs.

The USBLC6-2SC6Y in open source designs

The gallery holds 5 open source boards using the USBLC6-2SC6Y from 5 GitHub repositories; a typical one measures about 50 × 60 mm and carries around 106 components.

50% are two-layer designs, the rest use four layers or more, and 20% carry an open source license.

The most starred is Zs1100a by zscircuits.

Microcontrollers on boards using the USBLC6-2SC6Y

What boards using the USBLC6-2SC6Y are built for

USBLC6-2SC6Y: common questions

Where can I find a USBLC6-2SC6Y reference design?

Each of the 5 boards on this page is a real design using the USBLC6-2SC6Y. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What decoupling capacitors do designs use on the USBLC6-2SC6Y VBUS pin?

The VBUS pin has a decoupling capacitor on 3 of 5 designs, most often 1 µF (then 22 µF). Counted from the KiCad layouts of 5 open source designs using the USBLC6-2SC6Y.

Which microcontrollers do boards using the USBLC6-2SC6Y use?

Most are built on STM32 (3) and PIC (1).

How big is a typical board using the USBLC6-2SC6Y?

The median is 50 × 60 mm, and 50% are two-layer designs.

What is the most popular open source board using the USBLC6-2SC6Y?

By GitHub stars, Zs1100a by zscircuits, with 76 stars.

Can I simulate one of these boards using the USBLC6-2SC6Y before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part