7 open source boards using the 10K

Real designs built with the 10K, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

7 boardsClear filters|Most starred

How designs wire the 10K

Read from the KiCad layouts of 6 open source designs, one per repository: what each pin of the 10K connects to, and the resistors, capacitors and other passives placed on it.

  • Pin 8 is tied to 5V on 2 of 2 designs.
Rpin 2, 5Connected to: The microcontroller 33%
  • Series resistor on 33% · 100 kΩ (1), 50 Ω (1)
Pin 8Connected to: 5V 100%

3 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include UltrasonicSystem by Sonicators, Kick-808 by marangisto, 遥控器 by CodonNine and NR1B-Analog by Flanagan-Lab-Neutron-Detector.

The 10K in open source designs

The gallery holds 7 open source boards using the 10K from 7 GitHub repositories; a typical one measures about 108.1 × 110 mm and carries around 70 components.

67% are two-layer designs, the rest use four layers or more, and 29% carry an open source license.

The most starred is UltrasonicSystem by Sonicators.

Microcontrollers on boards using the 10K

What boards using the 10K are built for

10K: common questions

Where can I find a 10K reference design?

Each of the 7 boards on this page is a real design using the 10K. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

How is the 10K pin 8 connected?

Pin 8 is tied to 5V on 2 of 2 designs. Counted from the KiCad layouts of 6 open source designs using the 10K.

Which microcontrollers do boards using the 10K use?

Most are built on AVR/Arduino (1), RP2040/RP2350 (1) and STM32 (1).

How big is a typical board using the 10K?

The median is 108.1 × 110 mm, and 67% are two-layer designs.

What is the most popular open source board using the 10K?

By GitHub stars, UltrasonicSystem by Sonicators, with 15 stars.

Can I simulate one of these boards using the 10K before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part