9 open source boards using the ATF22V10C

Real designs built with the ATF22V10C, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

9 boardsClear filters|Most starred

How designs wire the ATF22V10C

Read from the KiCad layouts of 5 open source designs, one per repository: what each pin of the ATF22V10C connects to, and the resistors, capacitors and other passives placed on it.

  • The VCC pin has a decoupling capacitor on 4 of 5 designs, most often 100 nF (then 1 µF).
  • The I/CLK pin has a pull-up to VCC on 2 of 5 designs, most often 10.5 kΩ.
I/CLKpin 1Connected to: A connector 60%
  • Pull-up to VCC on 40% · 10.5 kΩ (1)
GNDpin 12Connected to: GND 100%
VCCpin 24Connected to: VCC 100%
  • Decoupling capacitor on 80% · 100 nF (3), 1 µF (1)

21 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include BITSY Mark I by codesmythe, 6309-Unleashed by FredericSegard, PikaPC IDE by techav-homebrew and Cpu6502 by nandgate.

The ATF22V10C in open source designs

The gallery holds 9 open source boards using the ATF22V10C from 5 GitHub repositories; a typical one measures about 112.5 × 101.6 mm and carries around 41 components.

67% are two-layer designs, the rest use four layers or more, and 11% carry an open source license.

The most starred is BITSY Mark I by codesmythe.

Parts used alongside the ATF22V10C

What boards using the ATF22V10C are built for

ATF22V10C: common questions

Where can I find a ATF22V10C reference design?

Each of the 9 boards on this page is a real design using the ATF22V10C. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What decoupling capacitors do designs use on the ATF22V10C VCC pin?

The VCC pin has a decoupling capacitor on 4 of 5 designs, most often 100 nF (then 1 µF). Counted from the KiCad layouts of 5 open source designs using the ATF22V10C.

What pull-up resistor is used on the ATF22V10C I/CLK pin?

The I/CLK pin has a pull-up to VCC on 2 of 5 designs, most often 10.5 kΩ. Counted from the KiCad layouts of 5 open source designs using the ATF22V10C.

What parts are used alongside the ATF22V10C?

The 74HCT245, 74HCT74 and AS6C4008-55PCN appear in the most repositories here.

How big is a typical board using the ATF22V10C?

The median is 112.5 × 101.6 mm, and 67% are two-layer designs.

What is the most popular open source board using the ATF22V10C?

By GitHub stars, BITSY Mark I by codesmythe, with 4 stars.

Can I simulate one of these boards using the ATF22V10C before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part