3 open source boards using the MCP79510
Real designs built with the MCP79510, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
Cbm micropet
fachat
190.2 × 100.3 mm183 parts2LGPL-3.010Csa ultracpu
fachat
160 × 100.2 mm175 parts4LGPL-3.09- schematic only · 96 partsAVR/Arduino
Esp32-lora environmental datalogger sink
SuryaTejaJakka14
96 partsNo license0
The MCP79510 in open source designs
The gallery holds 3 open source boards using the MCP79510 from 3 GitHub repositories; a typical one measures about 175.1 × 100.2 mm and carries around 175 components.
50% are two-layer designs, the rest use four layers or more, and 67% carry an open source license.
The most starred is Cbm micropet by fachat.
Parts used alongside the MCP79510
Microcontrollers on boards using the MCP79510
What boards using the MCP79510 are built for
MCP79510: common questions
Where can I find a MCP79510 reference design?
Each of the 3 boards on this page is a real design using the MCP79510. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
What parts are used alongside the MCP79510?
The 74138D, ETHOLIENC, SD-CARD-GRAVI, SPIFLASH and W65C816SPLCC appear in the most repositories here.
Which microcontrollers do boards using the MCP79510 use?
Most are built on AVR/Arduino (1).
How big is a typical board using the MCP79510?
The median is 175.1 × 100.2 mm, and 50% are two-layer designs.
What is the most popular open source board using the MCP79510?
By GitHub stars, Cbm micropet by fachat, with 10 stars.
Can I simulate one of these boards using the MCP79510 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.