3 open source boards using the xESC2
Real designs built with the xESC2, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
AVR/Arduino
Hw openmower yardforce
xtech
180 × 170 mm275 parts4LCC-BY-4.012Hw openmower sabo
xtech
254 × 115 mm322 parts6LCC-BY-NC-4.05Hw module xesc
xtech
35 × 100.5 mm47 parts4LCC-BY-4.00
The xESC2 in open source designs
The gallery holds 3 open source boards using the xESC2 from 3 GitHub repositories; a typical one measures about 180 × 115 mm and carries around 275 components.
100% use four copper layers or more, and 67% carry an open source license.
The most starred is Hw openmower yardforce by xtech.
Parts used alongside the xESC2
Microcontrollers on boards using the xESC2
What boards using the xESC2 are built for
xESC2: common questions
Where can I find a xESC2 reference design?
Each of the 3 boards on this page is a real design using the xESC2. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
What parts are used alongside the xESC2?
The 2.54mm 1x5 socket, 2.54mm 1x6 socket, 2.54mm 1x9 socket, 2.54mm 2x2 socket and 2.54mm 2x6 socket appear in the most repositories here.
Which microcontrollers do boards using the xESC2 use?
Most are built on AVR/Arduino (1).
How big is a typical board using the xESC2?
The median is 180 × 115 mm, and 0% are two-layer designs.
What is the most popular open source board using the xESC2?
By GitHub stars, Hw openmower yardforce by xtech, with 12 stars.
Can I simulate one of these boards using the xESC2 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.