3 open source boards using the 1V2

Real designs built with the 1V2, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

3 boardsClear filters|Most starred

The 1V2 in open source designs

The gallery holds 3 open source boards using the 1V2 from 2 GitHub repositories; a typical one measures about 73 × 37 mm and carries around 133 components.

100% use four copper layers or more, and 0% carry an open source license.

The most starred is ICEBreaker by frohro.

Parts used alongside the 1V2

Microcontrollers on boards using the 1V2

What boards using the 1V2 are built for

1V2: common questions

Where can I find a 1V2 reference design?

Each of the 3 boards on this page is a real design using the 1V2. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What parts are used alongside the 1V2?

The 12MHz, 3.3V, 93C46B-SOT-23-6 and FT2232H appear in the most repositories here.

Which microcontrollers do boards using the 1V2 use?

Most are built on FPGA (3).

How big is a typical board using the 1V2?

The median is 73 × 37 mm, and 0% are two-layer designs.

What is the most popular open source board using the 1V2?

By GitHub stars, ICEBreaker by frohro, with 0 stars.

Can I simulate one of these boards using the 1V2 before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part