4 open source boards using the C190271
Real designs built with the C190271, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
FPGA
HaasoscopePro
drandyhaas
224.5 × 160 mm586 parts10LMIT482FPGA
ProgrammaGull Sandpiper
4n3m4i1
100 × 75 mm213 parts4LMIT0PGL FTDI Prog
4n3m4i1
42 × 22 mm46 parts4LMIT0- schematic only · 63 partsFPGA
ProgrammaGull E3
4n3m4i1
63 parts4LMIT0
The C190271 in open source designs
The gallery holds 4 open source boards using the C190271 from 2 GitHub repositories; a typical one measures about 100 × 75 mm and carries around 138 components.
100% use four copper layers or more, and 100% carry an open source license.
The most starred is HaasoscopePro by drandyhaas.
Microcontrollers on boards using the C190271
What boards using the C190271 are built for
C190271: common questions
Where can I find a C190271 reference design?
Each of the 4 boards on this page is a real design using the C190271. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the C190271 use?
Most are built on FPGA (3).
How big is a typical board using the C190271?
The median is 100 × 75 mm, and 0% are two-layer designs.
What is the most popular open source board using the C190271?
By GitHub stars, HaasoscopePro by drandyhaas, with 482 stars.
Can I simulate one of these boards using the C190271 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.