10 open source boards using the NSL-32
Real designs built with the NSL-32, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
KiClearance
upb-lea
21.8 × 15 mm6 parts2LNo license16Electronics uldosc
mpinese
100 × 70 mm54 parts2LNo license6AVR/Arduino
Etera uart bridge
Lenart12
100 × 100 mm63 parts2LNo license2RoboBallersLine
RoboBallers
132 × 132 mm116 parts2LNo license0AVR/Arduino
Ardubell
dh2pp
60 × 60 mm45 parts2LNo license0- schematic only · 56 partsSTM32
Stm32l4-heater
CSpyridakis
56 partsMIT0 STM32
Digital Board Rev 1
jer-lil
101.6 × 101.6 mm85 parts4LNo license0STM32
AnalogBoard Rev3
jer-lil
59.5 × 114.5 mm56 parts4LNo license0Charging Shutdown Circuit
formulaslug
139.7 × 88.9 mm37 parts2LNo license2Optocoupler
ArunCH404
33.3 × 28.7 mm7 parts2LNo license0
How designs wire the NSL-32
Read from the KiCad layouts of 8 open source designs, one per repository: what each pin of the NSL-32 connects to, and the resistors, capacitors and other passives placed on it.
| Pin | Connected to | Parts on the pin |
|---|---|---|
| Apin 1 | Connected to: A connector 38% |
|
2 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include KiClearance by upb-lea, Electronics uldosc by mpinese, Charging Shutdown Circuit by formulaslug and Etera uart bridge by Lenart12.
The NSL-32 in open source designs
The gallery holds 10 open source boards using the NSL-32 from 9 GitHub repositories; a typical one measures about 100 × 88.9 mm and carries around 55 components.
78% are two-layer designs, the rest use four layers or more, and 10% carry an open source license.
The most starred is KiClearance by upb-lea.
Microcontrollers on boards using the NSL-32
What boards using the NSL-32 are built for
NSL-32: common questions
Where can I find a NSL-32 reference design?
Each of the 10 boards on this page is a real design using the NSL-32. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
Which microcontrollers do boards using the NSL-32 use?
Most are built on STM32 (3) and AVR/Arduino (2).
How big is a typical board using the NSL-32?
The median is 100 × 88.9 mm, and 78% are two-layer designs.
What is the most popular open source board using the NSL-32?
By GitHub stars, KiClearance by upb-lea, with 16 stars.
Can I simulate one of these boards using the NSL-32 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.