4 open source boards using the INA199A1DC
Real designs built with the INA199A1DC, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
Radioberry preamp
pa3gsb
65 × 56 mm137 parts2LNo license675
Radioberry preamp
saktheeswaranswan
65 × 56 mm137 parts2LNo license0
Vswr extension bridge route
OE9SAU
83.7 × 37 mm50 parts2LNo license4
Vswr extension bridge
84 × 37 mm49 parts2LNo license4
The INA199A1DC in open source designs
The gallery holds 4 open source boards using the INA199A1DC from 3 GitHub repositories; a typical one measures about 74.3 × 46.5 mm and carries around 94 components.
100% are two-layer designs, the rest use four layers or more, and 0% carry an open source license.
The most starred is Radioberry preamp by pa3gsb.
Parts used alongside the INA199A1DC
What boards using the INA199A1DC are built for
INA199A1DC: common questions
Where can I find a INA199A1DC reference design?
Each of the 4 boards on this page is a real design using the INA199A1DC. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
What parts are used alongside the INA199A1DC?
The LD1117S33, MAX11613, LP2985, MCP4662 and ST1S10 appear in the most repositories here.
How big is a typical board using the INA199A1DC?
The median is 74.3 × 46.5 mm, and 100% are two-layer designs.
What is the most popular open source board using the INA199A1DC?
By GitHub stars, Radioberry preamp by pa3gsb, with 675 stars.
Can I simulate one of these boards using the INA199A1DC before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.