3 open source boards using the ST1S10
Real designs built with the ST1S10, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
PICHL2-Companion board codec and-Filter-
bnamnaidu
100 × 100 mm192 parts2LNo license4
Radioberry preamp
pa3gsb
65 × 56 mm137 parts2LNo license675
Radioberry preamp
saktheeswaranswan
65 × 56 mm137 parts2LNo license0
The ST1S10 in open source designs
The gallery holds 3 open source boards using the ST1S10 from 3 GitHub repositories; a typical one measures about 65 × 56 mm and carries around 137 components.
100% are two-layer designs, the rest use four layers or more, and 0% carry an open source license.
The most starred is Radioberry preamp by pa3gsb.
Parts used alongside the ST1S10
Microcontrollers on boards using the ST1S10
What boards using the ST1S10 are built for
ST1S10: common questions
Where can I find a ST1S10 reference design?
Each of the 3 boards on this page is a real design using the ST1S10. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
What parts are used alongside the ST1S10?
The INA199A1DC, LD1117S33, LP2985, MAX11613 and MCP4662 appear in the most repositories here.
Which microcontrollers do boards using the ST1S10 use?
Most are built on PIC (1).
How big is a typical board using the ST1S10?
The median is 65 × 56 mm, and 100% are two-layer designs.
What is the most popular open source board using the ST1S10?
By GitHub stars, Radioberry preamp by pa3gsb, with 675 stars.
Can I simulate one of these boards using the ST1S10 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.