6 open source boards using the LM35-NEB

Real designs built with the LM35-NEB, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

6 boardsClear filters|Most starred

How designs wire the LM35-NEB

Read from the KiCad layouts of 5 open source designs, one per repository: what each pin of the LM35-NEB connects to, and the resistors, capacitors and other passives placed on it.

  • The +VS pin is tied to 5V on 5 of 5 designs.
  • The VOUT pin has a series resistor on 2 of 5 designs, most often 10 kΩ.
+VSpin 1Connected to: 5V 100%
GNDpin 2Connected to: GND 100%
VOUTpin 3Connected to: The microcontroller 40%
  • Series resistor on 40% · 10 kΩ (2)

Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include SmartElevatorSystem by anwaypimpalkar, Electricload by hnz1102, Dcpower by hnz1102 and Project-04-Predictive-Maintenance system-PCB by Darshan7052006.

The LM35-NEB in open source designs

The gallery holds 6 open source boards using the LM35-NEB from 5 GitHub repositories; a typical one measures about 89 × 99 mm and carries around 28 components.

67% are two-layer designs, the rest use four layers or more, and 0% carry an open source license.

The most starred is SmartElevatorSystem by anwaypimpalkar.

Microcontrollers on boards using the LM35-NEB

What boards using the LM35-NEB are built for

LM35-NEB: common questions

Where can I find a LM35-NEB reference design?

Each of the 6 boards on this page is a real design using the LM35-NEB. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

How is the LM35-NEB +VS pin connected?

The +VS pin is tied to 5V on 5 of 5 designs. Counted from the KiCad layouts of 5 open source designs using the LM35-NEB.

What resistor goes on the LM35-NEB VOUT pin?

The VOUT pin has a series resistor on 2 of 5 designs, most often 10 kΩ. Counted from the KiCad layouts of 5 open source designs using the LM35-NEB.

What parts are used alongside the LM35-NEB?

The ESP32-S3-WROOM-1-N16R8, INA228, OPA187IDBVR, SSD1331_DISPLAY and TSB611ILT appear in the most repositories here.

Which microcontrollers do boards using the LM35-NEB use?

Most are built on ESP32 (3), ESP8266 (2) and AVR/Arduino (1).

How big is a typical board using the LM35-NEB?

The median is 89 × 99 mm, and 67% are two-layer designs.

What is the most popular open source board using the LM35-NEB?

By GitHub stars, SmartElevatorSystem by anwaypimpalkar, with 6 stars.

Can I simulate one of these boards using the LM35-NEB before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part