26 open source boards using the ProMicro_r

Real designs built with the ProMicro_r, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

26 boardsClear filters|Most starred

How designs wire the ProMicro_r

Read from the KiCad layouts of 9 open source designs, one per repository: what each pin of the ProMicro_r connects to, and the resistors, capacitors and other passives placed on it.

GNDpin 3, 4, 23Connected to: GND 93%
SDA/D1/2pin 5Connected to: A connector 33% · not connected 33%
  • Pull-up to VCC on 33% · 4.7 kΩ (1)
SCL/D0/3pin 6Connected to: A connector 33% · not connected 33%
  • Pull-up to VCC on 33% · 4.7 kΩ (1)
VCCpin 21Connected to: VCC 78%

18 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Hillside Keyboard by mmccoyd, Asfoora by AlaaSaadAbdo, PNCATEHO MK DOSE by aroum and Musashi60 by hamano.

The ProMicro_r in open source designs

The gallery holds 26 open source boards using the ProMicro_r from 9 GitHub repositories; a typical one measures about 146.2 × 100.5 mm and carries around 61 components.

96% are two-layer designs, the rest use four layers or more, and 58% carry an open source license.

The most starred is Hillside52 Keyboard by mmccoyd.

What boards using the ProMicro_r are built for

ProMicro_r: common questions

Where can I find a ProMicro_r reference design?

Each of the 26 boards on this page is a real design using the ProMicro_r. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

How big is a typical board using the ProMicro_r?

The median is 146.2 × 100.5 mm, and 96% are two-layer designs.

What is the most popular open source board using the ProMicro_r?

By GitHub stars, Hillside52 Keyboard by mmccoyd, with 444 stars.

Can I simulate one of these boards using the ProMicro_r before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part