21 open source boards using the USBLC6-4

Real designs built with the USBLC6-4, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

21 boardsClear filters|Most starred

How designs wire the USBLC6-4

Read from the KiCad layouts of 14 open source designs, one per repository: what each pin of the USBLC6-4 connects to, and the resistors, capacitors and other passives placed on it.

GNDpin 2Connected to: GND 100%
VBUSpin 5Connected to: 5V 71% · a signal 29%

4 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include OtterPill by Jana-Marie, EF-S-Adapter by Jana-Marie, Temperature logger by Jana-Marie and Blixten by jonasblixt.

The USBLC6-4 in open source designs

The gallery holds 21 open source boards using the USBLC6-4 from 14 GitHub repositories; a typical one measures about 68.4 × 44 mm and carries around 63 components.

62% are two-layer designs, the rest use four layers or more, and 76% carry an open source license.

The most starred is OtterPill by Jana-Marie.

Microcontrollers on boards using the USBLC6-4

USBLC6-4: common questions

Where can I find a USBLC6-4 reference design?

Each of the 21 boards on this page is a real design using the USBLC6-4. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What parts are used alongside the USBLC6-4?

The STM32F072CBTx, AP2204R-3.3, ATTINY48-QFN, LAN8710 and LP3470M5-3.08 appear in the most repositories here.

Which microcontrollers do boards using the USBLC6-4 use?

Most are built on STM32 (13), AVR/Arduino (2), ESP32 (1) and Microchip SAM (1).

How big is a typical board using the USBLC6-4?

The median is 68.4 × 44 mm, and 62% are two-layer designs.

What is the most popular open source board using the USBLC6-4?

By GitHub stars, OtterPill by Jana-Marie, with 162 stars.

Can I simulate one of these boards using the USBLC6-4 before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part