8 open source boards using the W27C512
Real designs built with the W27C512, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.
65uino
AndersBNielsen
74.4 × 53.6 mm80 parts2LCustom license165QL QsoundQprint clone
alvaroalea
99.1 × 99.1 mm22 parts2LCERN-OHL-S-2.011Betadisk clone
alvaroalea
99.7 × 149.9 mm83 parts2LNo license7Zx81-external eprom
zxinfo-diy-electronics
60.3 × 52.4 mm13 parts2LNo license7Main
ceteras
299.2 × 180 mm434 parts2LMIT5Zx interface-2-rom
zxinfo-diy-electronics
39.4 × 50.1 mm8 parts2LNo license2MEM
KALTCHUK
99.7 × 69.9 mm28 parts2LNo license94RAM
TheJustMoose
99.1 × 99.1 mm26 parts2LNo license2
How designs wire the W27C512
Read from the KiCad layouts of 8 open source designs, one per repository: what each pin of the W27C512 connects to, and the resistors, capacitors and other passives placed on it.
| Pin | Connected to | Parts on the pin |
|---|---|---|
| A15pin 1 | Connected to: Signal 88% |
|
| GNDpin 14 | Connected to: GND 100% | — |
| VCCpin 28 | Connected to: 5V 100% |
|
25 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include 65uino by AndersBNielsen, MEM by KALTCHUK, QL QsoundQprint clone by alvaroalea and Betadisk clone by alvaroalea.
The W27C512 in open source designs
The gallery holds 8 open source boards using the W27C512 from 8 GitHub repositories; a typical one measures about 99.1 × 84.5 mm and carries around 27 components.
100% are two-layer designs, the rest use four layers or more, and 25% carry an open source license.
The most starred is 65uino by AndersBNielsen.
Parts used alongside the W27C512
What boards using the W27C512 are built for
W27C512: common questions
Where can I find a W27C512 reference design?
Each of the 8 boards on this page is a real design using the W27C512. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.
What parts are used alongside the W27C512?
The 74LS74, 74LS00, 74LS04, 74LS10 and 74LS139 appear in the most repositories here.
How big is a typical board using the W27C512?
The median is 99.1 × 84.5 mm, and 100% are two-layer designs.
What is the most popular open source board using the W27C512?
By GitHub stars, 65uino by AndersBNielsen, with 165 stars.
Can I simulate one of these boards using the W27C512 before building it?
Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.