40 open source boards using the Elite-C

Real designs built with the Elite-C, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

40 boardsClear filters|Most starred

How designs wire the Elite-C

Read from the KiCad layouts of 21 open source designs, one per repository: what each pin of the Elite-C connects to, and the resistors, capacitors and other passives placed on it.

GNDpin 3, 4, 23Connected to: GND 67% · not connected 24%
VCCpin 21Connected to: VCC 71% · not connected 19%

25 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include ${PRODUCT} by moduloindustries, Barghoot by AlaaSaadAbdo, EliteMicro2040 by Envious-Data and Alpha29 pmw3360 by Skycode22.

The Elite-C in open source designs

The gallery holds 40 open source boards using the Elite-C from 22 GitHub repositories; a typical one measures about 300.1 × 105.9 mm and carries around 132 components.

100% are two-layer designs, the rest use four layers or more, and 43% carry an open source license.

The most starred is ${PRODUCT} by moduloindustries.

Parts used alongside the Elite-C

Microcontrollers on boards using the Elite-C

Elite-C: common questions

Where can I find a Elite-C reference design?

Each of the 40 boards on this page is a real design using the Elite-C. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

Which microcontrollers do boards using the Elite-C use?

Most are built on AVR/Arduino (3) and RP2040/RP2350 (2).

How big is a typical board using the Elite-C?

The median is 300.1 × 105.9 mm, and 100% are two-layer designs.

What is the most popular open source board using the Elite-C?

By GitHub stars, ${PRODUCT} by moduloindustries, with 317 stars.

Can I simulate one of these boards using the Elite-C before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part