2 open source boards using the 30P

Real designs built with the 30P, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

2 boardsClear filtersOpen license only|Most starred Recently updated Most components

The 30P in open source designs

The gallery holds 2 open source boards using the 30P from 2 GitHub repositories; a typical one measures about 43.5 × 52.5 mm and carries around 45 components.

100% are two-layer designs, the rest use four layers or more, and 0% carry an open source license.

The most starred is GPS-Tracker by mohamedboubaker.

Parts used alongside the 30P

Microcontrollers on boards using the 30P

STM32 2

What boards using the 30P are built for

30P: common questions

Where can I find a 30P reference design?

Each of the 2 boards on this page is a real design using the 30P. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What parts are used alongside the 30P?

The 100N, 10N, 10P, 10U and 4U7 appear in the most repositories here.

Which microcontrollers do boards using the 30P use?

Most are built on STM32 (2).

How big is a typical board using the 30P?

The median is 43.5 × 52.5 mm, and 100% are two-layer designs.

What is the most popular open source board using the 30P?

By GitHub stars, GPS-Tracker by mohamedboubaker, with 40 stars.

Can I simulate one of these boards using the 30P before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.