15 open source boards using the Buck

Real designs built with the Buck, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

15 boardsClear filters|Most starred

How designs wire the Buck

Read from the KiCad layouts of 10 open source designs, one per repository: what each pin of the Buck connects to, and the resistors, capacitors and other passives placed on it.

  • Pin IN is tied to 12V on 5 of 5 designs.
  • Pin IN_GND is tied to GND on 5 of 5 designs.
  • Pin OUT_GND is tied to GND on 5 of 5 designs.
  • The IN- pin is tied to GND on 4 of 5 designs.
IN-pin 2Connected to: GND 80% · 5V 20%
OUT+pin 3Connected to: GND 60% · a signal 40%
OUT-pin 4Connected to: 12V 60% · GND 40%
Pin INConnected to: 12V 100%
Pin IN_GNDConnected to: GND 100%
Pin OUT_GNDConnected to: GND 100%

2 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include ChainlinkBase by scottbez1, Psu by eshazen, BMS Project by tjorvenhillmann and LCD LOCONET SHIELD by bask185.

The Buck in open source designs

The gallery holds 15 open source boards using the Buck from 10 GitHub repositories; a typical one measures about 100 × 95.3 mm and carries around 119 components.

93% are two-layer designs, the rest use four layers or more, and 73% carry an open source license.

The most starred is ChainlinkDriverTester by scottbez1.

Microcontrollers on boards using the Buck

Buck: common questions

Where can I find a Buck reference design?

Each of the 15 boards on this page is a real design using the Buck. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

How is the Buck pin IN connected?

Pin IN is tied to 12V on 5 of 5 designs. Counted from the KiCad layouts of 10 open source designs using the Buck.

How is the Buck pin IN_GND connected?

Pin IN_GND is tied to GND on 5 of 5 designs. Counted from the KiCad layouts of 10 open source designs using the Buck.

How is the Buck pin OUT_GND connected?

Pin OUT_GND is tied to GND on 5 of 5 designs. Counted from the KiCad layouts of 10 open source designs using the Buck.

What parts are used alongside the Buck?

The AP7361C-33E, INA219BxD, LM7805_TO220, MCP23017_SS and SN74LV1T34DBV appear in the most repositories here.

Which microcontrollers do boards using the Buck use?

Most are built on AVR/Arduino (3) and NXP (1).

How big is a typical board using the Buck?

The median is 100 × 95.3 mm, and 93% are two-layer designs.

What is the most popular open source board using the Buck?

By GitHub stars, ChainlinkDriverTester by scottbez1, with 4,156 stars.

Can I simulate one of these boards using the Buck before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part