19 open source boards using the OLED

Real designs built with the OLED, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

19 boardsClear filters|Most starred

How designs wire the OLED

Read from the KiCad layouts of 17 open source designs, one per repository: what each pin of the OLED connects to, and the resistors, capacitors and other passives placed on it.

VCCpin 2Connected to: 3.3V 65% · GND 18% · a signal 18%

3 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Opensolder by howie-j, C64 Pi1541-III Module Panel by tebl, RC Dashboard SuperMini2 by tebl and Precision-Digital-Micro-Current-Meter by jobitjoseph.

The OLED in open source designs

The gallery holds 19 open source boards using the OLED from 17 GitHub repositories; a typical one measures about 90 × 61 mm and carries around 28 components.

84% are two-layer designs, the rest use four layers or more, and 47% carry an open source license.

The most starred is Opensolder by howie-j.

Parts used alongside the OLED

Microcontrollers on boards using the OLED

OLED: common questions

Where can I find a OLED reference design?

Each of the 19 boards on this page is a real design using the OLED. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What parts are used alongside the OLED?

The Bluetooth, LTC1050 and Capteur_graphite appear in the most repositories here.

Which microcontrollers do boards using the OLED use?

Most are built on STM32 (4), AVR/Arduino (3), RP2040/RP2350 (3) and ESP32 (2).

How big is a typical board using the OLED?

The median is 90 × 61 mm, and 84% are two-layer designs.

What is the most popular open source board using the OLED?

By GitHub stars, Opensolder by howie-j, with 51 stars.

Can I simulate one of these boards using the OLED before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part