19 open source boards using the TPD4EUSB30DQAR

Real designs built with the TPD4EUSB30DQAR, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

19 boardsClear filters|Most starred

How designs wire the TPD4EUSB30DQAR

Read from the KiCad layouts of 17 open source designs, one per repository: what each pin of the TPD4EUSB30DQAR connects to, and the resistors, capacitors and other passives placed on it.

GNDpin 3, 8Connected to: GND 100%

5 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Pintry by icamaster, Picard by weiiwang01, V2 mini by teehee567 and Logic analyzer by cheyao.

The TPD4EUSB30DQAR in open source designs

The gallery holds 19 open source boards using the TPD4EUSB30DQAR from 17 GitHub repositories; a typical one measures about 90 × 76.8 mm and carries around 112 components.

89% use four copper layers or more, and 47% carry an open source license.

The most starred is Pintry by icamaster.

Microcontrollers on boards using the TPD4EUSB30DQAR

TPD4EUSB30DQAR: common questions

Where can I find a TPD4EUSB30DQAR reference design?

Each of the 19 boards on this page is a real design using the TPD4EUSB30DQAR. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What parts are used alongside the TPD4EUSB30DQAR?

The 74LVC1G07SE-7, AP64501SP-13, AP22653W6-7, FSUSB42MUX and RT9742GGJ5 appear in the most repositories here.

Which microcontrollers do boards using the TPD4EUSB30DQAR use?

Most are built on Raspberry Pi (5), ESP32 (3), STM32 (3) and AVR/Arduino (2).

How big is a typical board using the TPD4EUSB30DQAR?

The median is 90 × 76.8 mm, and 11% are two-layer designs.

What is the most popular open source board using the TPD4EUSB30DQAR?

By GitHub stars, Pintry by icamaster, with 26 stars.

Can I simulate one of these boards using the TPD4EUSB30DQAR before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part