43 open source boards using the 25MHZ

Real designs built with the 25MHZ, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

43 boardsClear filters|Most starred

How designs wire the 25MHZ

Read from the KiCad layouts of 30 open source designs, one per repository: what each pin of the 25MHZ connects to, and the resistors, capacitors and other passives placed on it.

  • The VIN pin has a decoupling capacitor on 29 of 30 designs, most often 100 nF (then 1 µF).
  • The EN pin is tied to 1.2V on 28 of 30 designs (a signal on 2).
ENpin 1Connected to: 1.2V 93%
GNDpin 2Connected to: GND 100%
VINpin 4Connected to: 1.2V 90%
  • Decoupling capacitor on 97% · 100 nF (29), 1 µF (27), 220 nF (1)

1 more pin varies from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Bitaxe by skot, BitaxeGamma by bitaxeorg, Qaxe by shufps and NerdOCTAXE-Gamma by Patsch91.

The 25MHZ in open source designs

The gallery holds 43 open source boards using the 25MHZ from 31 GitHub repositories; a typical one measures about 89 × 99.8 mm and carries around 183 components.

95% use four copper layers or more, and 79% carry an open source license.

The most starred is Bitaxe by skot.

Microcontrollers on boards using the 25MHZ

25MHZ: common questions

Where can I find a 25MHZ reference design?

Each of the 43 boards on this page is a real design using the 25MHZ. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What decoupling capacitors do designs use on the 25MHZ VIN pin?

The VIN pin has a decoupling capacitor on 29 of 30 designs, most often 100 nF (then 1 µF). Counted from the KiCad layouts of 30 open source designs using the 25MHZ.

How is the 25MHZ EN pin connected?

The EN pin is tied to 1.2V on 28 of 30 designs (a signal on 2). Counted from the KiCad layouts of 30 open source designs using the 25MHZ.

What parts are used alongside the 25MHZ?

The MCP1824T-0802E, ESP32-S3-WROOM-1, EMC2101, RT9080-33GJ5 and BM1370_MODE1 appear in the most repositories here.

Which microcontrollers do boards using the 25MHZ use?

Most are built on ESP32 (24), RP2040/RP2350 (2) and STM32 (2).

How big is a typical board using the 25MHZ?

The median is 89 × 99.8 mm, and 5% are two-layer designs.

What is the most popular open source board using the 25MHZ?

By GitHub stars, Bitaxe by skot, with 1,375 stars.

Can I simulate one of these boards using the 25MHZ before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part