50 open source boards using the MCP3008

Real designs built with the MCP3008, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

50 boardsClear filters|Most starred

How designs wire the MCP3008

Read from the KiCad layouts of 39 open source designs, one per repository: what each pin of the MCP3008 connects to, and the resistors, capacitors and other passives placed on it.

DGNDpin 9Connected to: GND 95%
AGNDpin 14Connected to: GND 95%
VREFpin 15Connected to: 3.3V 76% · a signal 24%
  • Decoupling capacitor on 32% · 100 nF (14), 1 µF (3), 2.2 µF (1)
VDDpin 16Connected to: 3.3V 92%
  • Decoupling capacitor on 38% · 100 nF (15), 1 µF (5), 2.2 µF (1)

12 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include ControllerBoard by inria-emeraude, Pogobot Head by nekonaute, DD Compute 1 by Acmex2564 and Fpga audio mixer by brockbyte.

The MCP3008 in open source designs

The gallery holds 50 open source boards using the MCP3008 from 43 GitHub repositories; a typical one measures about 100 × 95.5 mm and carries around 68 components.

70% are two-layer designs, the rest use four layers or more, and 28% carry an open source license.

The most starred is ControllerBoard by inria-emeraude.

Microcontrollers on boards using the MCP3008

MCP3008: common questions

Where can I find a MCP3008 reference design?

Each of the 50 boards on this page is a real design using the MCP3008. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What parts are used alongside the MCP3008?

The RP2040, AMS1117-3.3, NCP1117-3.3_SOT223, PCA9685PW and RaspberryPi_Pico appear in the most repositories here.

Which microcontrollers do boards using the MCP3008 use?

Most are built on RP2040/RP2350 (10), Raspberry Pi (6), AVR/Arduino (3) and NXP (2).

How big is a typical board using the MCP3008?

The median is 100 × 95.5 mm, and 70% are two-layer designs.

What is the most popular open source board using the MCP3008?

By GitHub stars, ControllerBoard by inria-emeraude, with 133 stars.

Can I simulate one of these boards using the MCP3008 before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part